C Sort Flex-Flex Couplings
The C Style coupling consists of two flex hubs, one sleeve and one particular accessory kit consisting of seals and snap rings.
CFR Sort Flex-Rigid Couplings
The CFR Sort coupling include 1 flex hub, a single rigid hub, one particular sleeve, a single accessory kit consisting of seals and snap rings.
Functions
Basic and inexpensive type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in spot
Readily available as vertical and horizontal couplings
Wide selection of distinctive variations for example full-flex, flex-rigid mill motor
Standard configurations are available of your shelf
Ordering Details
Application: Driver and Driven.
Variety and size of coupling, horizontal, vertical and so forth.
Energy: Motor horspower or torque necessity.
Pace: Motor RPM or Driven RPM.
Distance concerning shaft ends (BSE).
Shaft sizes.
C and CFR Style Couplings
Ordering Information and facts
Puller Holes are standard on sizes 4 by twelve.
Puller Holes can be found for sizes 7/8 through three.5 at an additional charge.
The BSE (distance Between Shaft Ends) may possibly fluctuate between G and G1.
Interference bores with no set screws are standard except if otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, check with Engineering Area.
Greater sizes can be found, please seek advice from Technical Assistance.