Electrical power UNITS FOR LIFT TABLE 1
Basic Description
This energy unit is designed exclusively for your compact lift table,Consisting of higher strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be broadly used during the business of logistic products including minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled by the solenoid valve with all the velocity controlled by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Standard Description
This electrical power unit is created exclusively for the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve and the speed controlled by the adjustable needle valve. When the lift rises to a substantial positoin, however the power supply is minimize, the decreasing movement is controlled by the guide override function.
Electrical power UNITS FOR LIFT TABLE three
Common Description
This power unit is built exclusively for the significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve as well as velocity controlled by a stress compensated movement manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This power unit is developed exclusively for the significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve along with the velocity managed through the adjustable needle valve. When the lift rises to a high positoin, but the energy provide is minimize, the lowering motion is controlled through the manual override function.
Distinctive Notes
1. This electrical power unit is of S3 duty cycle, which may only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic components concerned in advance of installation of the electrical power unit.
3. Viscosity of your oil shoud be 15~46 cst,which ought to also be clean and totally free of impurities.N46 hydraulic oil is advised.
4. Oil shifting is required just after the first one hundred operation hours,afterwards after each and every 3000 hours.
five. The electrical power unit shown is created to be mounted vertically.