Planetary gear reducer installation method

In the category of reducers, planetary gearbox are trusted in servo, stepping, DC and other transmission systems due to their small size, high transmission efficiency, wide deceleration range and high accuracy. Its role is to lessen the speed boost torque and decrease the load/motor moment of inertia ratio under the premise of ensuring precision transmission. In the past Taper Pulleys couple of years, some users have suffered from unnecessary harm when the reducer is definitely broken because of human elements such as illegal installation. Therefore, to be able to better help the users to use the reducer, I’ll introduce you at length how to properly install the planetary reducer.
Proper installation, use and maintenance of the reducer is an important component of ensuring the standard operation of mechanical equipment. Consequently, when setting up the planetary gear reducer, be certain to properly assemble and use it in rigid accordance with the following installation and use.
First step
Before installation, confirm if the motor and gear reducer are intact, and strictly check if the dimensions of the parts linked to the reducer are matched. Listed below are the dimensions and matching tolerances of the positioning boss, input shaft and reducer groove of the engine.
Second step
Unscrew the screw on the outer side of the flange of the reducer flange, change the clamping ring of the PCS program so that the medial side holes are aligned with the dirt holes, and put in the hexagon socket into the hexagon. After that, remove the motor shaft key.
third step
Connect the motor to the reducer naturally. When connecting, it should be ensured that the output shaft of the reducer can be concentric with the insight shaft of the electric motor, and the outer flanges of both are parallel. As the center is inconsistent, it’ll cause the engine shaft to break or the reducer gear to wear.
In addition, it really is strictly forbidden to hit with a hammer or the like during installation to avoid damage to the bearing or equipment due to excessive axial force or radial force. Make sure to tighten the mounting bolts before tightening the tightening bolts. Before installation, wipe the anti-rust essential oil of the motor insight shaft, positioning boss and reducer reference to gasoline or zinc-sodium water. Its purpose is certainly to ensure the tightness of the bond and the flexibility of operation, and to prevent unnecessary wear.
Before connecting the motor to the gearbox, the motor shaft keyway should be perpendicular to the tightening bolt. To make sure uniform drive, first screw the mounting bolts at any diagonal position, but do not tighten them. Then screw on the mounting bolts at the various other two diagonal positions and lastly tighten the four mounting bolts one by one. Finally, tighten the tightening bolts. All tightening bolts are to be set and inspected using the torque wrenches according to the indicated fixed torque data.
The correct installation between your gearbox and the mechanical equipment is comparable to the correct installation between your reducer and the get motor. The main element is to make sure that the result shaft of the reducer is certainly concentric with the shaft of the powered part.