January 22, 2021

SMR Gearbox Installation
Satisfactory overall performance will depend on correct set up. lubrication and servicing. as a result it’s important the directions within the set up and servicing leaflet. supplied with each and every gearbox. are followed carefully. some of the significant facets of belt and torque-arm installation are listed beneath.
1. Install pulley on gearbox input shaft as near to the reducer achievable, and mount reducer on driven shaft as shut to bearing as sensible. failure to accomplish this may lead to extra loads in the input shaft bearings and output bearings and could bring about their premature failure.
two. Install motor and wedge belt drive with the belt pull at somewhere around 90° to the center line among driven and input shafts. this can allow tensioning of your wedge belt drive with the torque arm which need to preferably be in stress. if output hub runs anti-clockwise. torque arm should be positioned the appropriate.
three. lnstall torque-arm fulcrum on a rigid assistance so that the torque-arm might be at about suitable angles on the center line with the driven shaft as well as the torque arm case bolt. ensure there is enough take up while in the turnbuckle for belt stress adjustment.
Retain near.
Bell drive may be positioned in any handy postion. should the torque arm will be to be utilised to tighten the belts, the drive need to be at about tight angle on the line amongst the input and output shafts.
Bell drive may very well be located on the suitable if wanted.
If output hub rotates clock-wise. position belt drive and torque arm in opposite course to that shown inside the illustration.
Torque arm and belt get up.
Torque arm could be mounted on the proper if preferred.