admin

November 14, 2019

A lot more than 50% of the compression and pumping systems over 3 MW require a variable-speed drive. Frequently medium-voltage Variator Gearbox motors fed by frequency converters and parallel shaft gears are chosen. Others are using epicyclic gears with a hydrodynamic superimposition drive.

Taking benefit of the state of the art in electric powered motors and frequency converters, the driving program for the superimposition of the earth carrier is based on a Long lasting Magnet Synchronous Superimposition (SI) engine and a dynamic Front-End Cycle Converter. So – E means Electric.
That is a high-speed gear drive system incorporating components that allow the use of a low-cost constant-speed (electric) driver for a variable-speed application.

A lot more than 50% of the compression and pumping systems above 3 MW require a variable-speed drive. Often medium-voltage motors fed by frequency converters and parallel shaft gears are chosen. Others are employing epicyclic gears with a hydrodynamic superimposition drive.
It started with hydraulic liquid couplings producing slippage with results very little much better than the throttle.
The look of hydraulic clutches then improved and included a torque converter and a superimposed epicyclic drive.
Variable Frequency Drives (VFD) were developed and, simultaneously, the expense of the shaft trains improved, and so did efficiency. The issue of THD (Total Harmonic grid Distortion) rose and kept VFD out of many applications.

Taking advantage of the state of the artwork in electric powered motors and frequency converters, the driving system for the superimposition of the planet carrier is based on a Long term Magnet Synchronous Superimposition (SI) motor and a dynamic Front-End Cycle Converter. So – E means Electric.
This is a high-speed gear drive system incorporating components that allow the use of a low-cost constant-speed (electric) driver for a variable-speed application.

All of the over plots were taken by analyzing the existing to the engine. In a normal scenario, the vibration will become monitored and kept on a periodic basis. If the 360 Hz signal is present in the vibration spectrum, it is not normally of any concern. If, however, other unexplained frequencies come in the vibration spectra, then it would be advisable to check out both the current waveform and the current spectrum. In the pages that follow, a few examples of problems found out in DC drives and motors are provided.”
It started with hydraulic liquid couplings creating slippage with results not much much better than the throttle.
The look of hydraulic clutches then improved and included a torque converter and a superimposed epicyclic drive.
Variable Frequency Drives (VFD) were developed and, simultaneously, the expense of the shaft trains improved, and so did efficiency. The problem of THD (Total Harmonic grid Distortion) rose and held VFD out of several applications.